Auto-Loader Batch Files; Learning How To Use Auto-Loader - Intermec JG2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual (4MB)

Auto-Loader Batch Files

When you install Auto-Loader onto your host computer, eight batch files are
copied to your host computer. You will use these batch files to change the
contents of drive C on the reader:
• LOAD_USA.BAT or LOADLANG.BAT
• LOADADD.BAT
• LOADC.BAT
• LOADIMG.BAT
• LOADNEW.BAT
• LOADXIMG.BAT
• MAKE_USA.BAT or MAKELANG.BAT
• MAKENEW.BAT
Note: The LOADC.BAT file is a master batch file called by the other batch files.
This section covers these topics:

• Learning How to Use Auto-Loader

• Moving the Batch Files
• Using an External Power Supply
• How to Use Each Batch File
Learning How to Use Auto-Loader
Follow either of these methods to create an image file, which contains the files
you want on the reader's drive C, and then load it onto the reader:
• Use LOAD_USA, LOADLANG, LOADADD, or LOADNEW to create and
• Use MAKE_USA, MAKELANG, or MAKENEW to create the image file and
For more help, see these chapters:
Chapter 3, "Learning About the Software" Describes how to install Auto-Loader,
explains why you must use special utilities to change drive C, and includes
instructions for executing the commonly used batch files.
D-10
load the image file in a single step.
store it on a host computer. Then use LOADIMG or LOADXIMG to load the
image file onto the reader. This two-step method helps you create an image
file to be loaded onto multiple JANUS readers.