Table of Contents
Advertisement
code39
nugget
EOR (End of Record)
Purpose:
Attaches an EOR to the end of every record of a file transmit.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
The configured option may be overridden when you use certain communications
protocols. EOR will not be overridden when you use User-Defined protocol.
Default:
Disabled
Syntax:
FBdata
where data can be one or two ASCII characters.
Scan:
To disable EOR, scan this bar code:
Disable EOR
*$+FB*
*$+FB*
Or:
To set the EOR character to an ASCII character(s):
1. Scan this bar code:
2. Scan one or two bar codes for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
helconital
Enter Accumulate Mode / Set EOR
*+/$+FB*
*+/$+FB*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Configuration Command Reference
12
12-55
Advertisement
Table of Contents
