code39
nugget
RES (Reset)
Purpose:
Enables or disables a reset event.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
Default:
Disabled
PCdata
Syntax:
where data can be any ASCII character.
Scan:
To disable RES, scan this bar code:
Disable RES
*$+PC*
*$+PC*
Or:
To set RES to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
helconital
Enter Accumulate Mode / Set RES
*+/$+PC*
*+/$+PC*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Configuration Command Reference
12
12-83