Table of Contents
Advertisement
JANUS 2010 Hand-Held Computer User's Manual (4MB)
3. At the DOS prompt on the host computer, type this command:
4. Wait for the installation procedure to finish and follow any instructions on
The installation creates the C_FILES\COMMON directory that contains the
default AUTOEXEC.BAT, CONFIG.SYS, and AUTOINST.BAT startup files.
You can edit these startup files before loading them onto the reader. Do not
remove or alter clearly commented statements that are required for Auto-
Loader.
The installation also creates eight batch files in the directory you created for
Auto-Loader. You will use LOADADD, LOADNEW, or LOADLANG to
configure the reader to operate in a language. To learn about the other batch
files, see "Auto-Loader Batch Files" in Appendix D.
Because the batch files are customized for the drive and directory where they
are installed, you must reinstall Auto-Loader to move the files. Also, because
the batch files are customized for the language you chose when you installed
Auto-Loader, you must reinstall Auto-Loader to switch to another language.
8-4
source :install [ country ] [ -port ]
where:
source
is the disk drive where you inserted companion disk 1.
country
specifies the country that corresponds to the language the
reader will operate in. Type a country name supported by DOS
NLS: France, Germany, Italy, or Spain. This parameter is
optional; the default is USA.
port
is the number of the host computer's serial COM port that the
reader is connected to. This parameter is optional; the default
is COM1.
Here are two examples:
• If companion disk 1 is in drive A, the reader is connected to the host
computer's COM1, and you want the reader to operate in French, type
this command on the host computer:
a:install france
• If companion disk 1 is in drive B, the reader is connected to the host
computer's COM2, and you want the reader to operate in Italian, type
this command on the host computer:
b:install italy -com2
the host computer's display.
Advertisement
Table of Contents
