Intermec JG2010 User Manual page 154

JANUS 2010 Hand-Held Computer User's Manual (4MB)
To run CARDINFO on the reader, type one of these commands at the DOS
prompt:
Command
cardinfo
cardinfo /off {: slot }
cardinfo /on {: slot }
cardinfo /c
cardinfo /v ¦more
cardinfo /?
Use CARDINFO to manage the reader's power when an I/O card is in the PC
card drive. For example, a modem card draws power even when it is not in
use, so you can conserve the NiCad battery pack by turning off the power to
the PC card drive when you are not using the modem card.
To turn off the power to the PC card drive
• When you are not using the modem card, type this command:
4-26
cardinfo /off:1
Or scan this bar code:
*CARDINFO /OOFF/Z1*
*CARDINFO /OFF*
Description
Displays information about the card inserted in each
PC card drive, including the type of card, size, card
manufacturer, and product name.
Turns off the power to all the PC card drives. Use the
slot option to turn off the power to only one PC card
drive. The JANUS 2010 Type I PC card drive is slot 0;
the Type II PC card drive is slot 1.
Turns on the power to all the PC card drives. Use the
slot option to turn on the power to only one PC card
drive. The JANUS 2010 Type I PC card drive is slot 0;
the Type II PC card drive is slot 1.
Displays information about the card in each PC card
drive, including the type of card, size, card
manufacturer, product name, and Card Services.
Displays extensive information about the card in each
PC card drive, including the type of card, size,
manufacturer, product name, Card Services, client,
and card configuration.
Use the DOS More switch because the output is
usually more than one screen long.
Displays information about CARDINFO options.