Intermec JG2010 User Manual page 114

JANUS 2010 Hand-Held Computer User's Manual
8. Copy the image file from the host computer to the PC card and then insert
9. At the DOS prompt on the JANUS device, type this command to load the
Example 2
In this example, you create the image file on the host computer, use Interlnk to
make the image file appear as if it were on the JANUS device, and use PutDisk
to load the image file to drive C.
1. Connect the JANUS device to a host computer using an appropriate serial
2. Create a source directory on the host computer by typing this command at
3. Fill the source directory with all the files you want to include in the new
4. Insert the JANUS Boot Utilities companion disk into a drive on the host PC.
5. Copy the self-expanding executable C_MAKE.EXE to drive C on the host
6
7. Type this command at the host computer's DOS prompt:
3-30
(4MB)CODE
the PC card into the JANUS PC card drive, drive G.
Note: It is recommended that you provide an external power supply for the
JANUS device before you execute PutDisk.
new image file onto drive C.
putdisk /i=g:\newdrv.img
connection.
the host computer's DOS prompt:
mkdir c:\drivec
image file:
a. Copy the files from the current JANUS drive C to the source directory
on the host PC. Use Interlnk with the host computer as the client and
the JANUS device as the server.
b. Add any other files to the source directory that you want on
drive C. These files may include read-only data files and applications
for your JANUS device.
Note: Do not create the image file in the directory where the source files reside.
c. Edit AUTOEXEC.BAT, CONFIG.SYS, and other files in the source
directory as necessary.
PC by typing:
copy a:\c_make.exe c:\
Run C_MAKE.EXE and delete all of the extracted files except for
MAKEDISK.EXE.
makedisk /s=c:\drivec /o=newdrv.img
CODENUGG
NUGG