Table of Contents
Advertisement
code39
nugget
POL
Purpose:
Solicits or requests data from a polled device.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
Default:
Disabled
HBdata
Syntax:
where data can be any ASCII character.
Scan:
To disable POL, scan this bar code:
Disable POL
*$+HB*
*$+HB*
Or:
To set POL to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
helconital
Enter Accumulate Mode / Set POL
*+/$+HB*
*+/$+HB*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Configuration Command Reference
12
12-77
Advertisement
Table of Contents
