Intermec JG2010 User Manual page 306

JANUS 2010 Hand-Held Computer User's Manual
Using DOS Commands and Applications (continued)
Problem
The host computer locks up after you
type this command on the reader:
intersvr /rcopy
The reader does not boot after you
modified the CONFIG.SYS file.
The reader locks up when you use
Interlnk and list a directory (DIR) on
one of the reader's ROM drives.
You see this message when you use
Interlnk/Intersvr to copy files
between the reader and the host
computer:
Not reading writing drive X
Abort, Fail, Retry
10-24
nugget
(4MB)nugget
Solution
When the Interlnk files are downloaded to the host computer, the
host computer may lock up. Reboot the host computer.
Correct the error in CONFIG.SYS. Use Auto-Loader, BFT, or
MakeDisk and PutDisk to load the new CONFIG.SYS onto the
reader.
Boot the reader. The reader should boot with the corrected
CONFIG.SYS file.
Edit the host computer's AUTOEXEC.BAT or CONFIG.SYS file and
remove or remark out Windows SMARTDRIVE.
Press to Retry and continue copying the files. You may have a
problem copying files if you use the DOS version (utilities from
your PC) of Interlnk and Intersvr on the JANUS reader. Intermec
modified the Interlnk and Intersvr utilities to work with the JANUS
reader. The Intermec version of these utilities is provided on the
reader's Drive D and on the MS-DOS Programs companion disk 2.
Use the Interlnk and Intersvr utilities provided with your reader to
transfer and copy files.
If your files were not copied correctly, try the procedure again using
the Interlnk and Intersvr utilities provided with your reader.
code code
he l conital