Irl End Program Block - Intermec JG2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual (4MB)
code39
nugget
IRL BAK (Bad Program Acknowledge) (continued)
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:

IRL End Program Block

Purpose: Indicates the last block of an IRL program when you download a program to
the reader.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
Default: SO (shift out)
Syntax: XDdata
where data can be any ASCII character.
To disable IRL End Program Block, scan this bar code:
Scan:
Disable IRL End Program Block
*$+XD*
*$+XD*
Or: To set IRL End Program Block to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
12-62
helconital
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Enter Accumulate Mode / IRL End Program Block
*+/$+XD*
*+/$+XD*
Appendix C.