Table of Contents
Advertisement
JANUS 2010 Hand-Held Computer User's Manual
Powering Up or Booting the Reader (continued)
Problem
When the reader finishes booting,
an icon remains on at the top of its
display.
Other Boot Loader menu messages
may look like this:
Boot Loader
Reboot
Password
Dump
Load
Resume
Storage
Off
Power-On Override
Okay To Resume
20X0A.001
10-6
nugget
(4MB)nugget
Solution
Contact your Intermec service representative. When the reader
boots, the CPU starts all power cycles and turns all icons (except for
Battery) on and off. The icons turn off very quickly as the reader
passes a series of bootstrap code checks. Any icon that remains on
indicates where the bootstrap code failed.
If you see "Bad Saved State," the device may have been in Storage
mode. Press
to reboot. If you are prompted to exit Storage
mode, press
again.
You may also see the "Bad Saved State" message if you press
suspend the device while it is booting. Press
device. You may be able to save the contents of the physical RAM
drive.
Other self-explanatory messages may display on bottom of the Boot
Loader menu.
For messages in the following group, choose Reboot on the Boot
Loader menu and press
"System Has Reset
Please Reboot"
"Bad CMOS Checksum, Errors
Please Reboot"
"DRAM Check Failed
Please Reboot"
For the messages in the following group, choose Resume or Reboot
on the Boot Loader menu and press
"Keypad Fault Found
Okay to Resume"
"Power-On Override
Okay to Resume"
"Power-Off Timeout, Errors
Okay to Resume"
"Power-Off Forced
Okay to Resume"
code
code
he l conital
to reboot the
.
.
to
Advertisement
Table of Contents
