Table of Contents
Advertisement
code39
nugget
Chapter 8, "Preparing the Reader for International Use" Describes how to use
Auto-Loader to configure the reader to operate in a DOS National Language
Support (NLS) language: French, German, Italian, or Spanish.
Moving the Batch Files
The batch files are customized for the drive and directory where you installed
them. To move the batch files, you must reinstall Auto-Loader. For help, see
"Installing Auto-Loader on Your Host Computer" in Chapter 3.
Using an External Power Supply
When you use Auto-Loader, you must connect an external power supply to the
communications dock or optical link adapter. Auto-Loader uses MakeDisk and
PutDisk software. Because PutDisk requires an external power supply,
Auto-Loader also requires an external power supply.
Caution
The reader should be powered by an AC power source when you use the PutDisk
command in case the battery pack goes low while the flash is being erased. If the
power goes down when using PutDisk, the reader locks up and the system flash
must be reloaded from the Boot Loader menu and you will lose data.
Conseil
Il faut alimenter le lecteur par une source de courant AC lors de l'exécution de la
commande PutDisk dans le cas où le jeu de piles s'affaiblit pendant l'effacement
du flash. Si le courant est coupé lors de l'exécution de PutDisk, le lecteur se
verrouille, le flash système doit être rechargé du menu d'amorçage (Boot Loader)
et vous perdez des données.
Using LOAD_USA
LOAD_USA creates an image file that contains only the three startup files in
the C_FILES\COMMON directory: AUTOEXEC.BAT, AUTOINST.BAT, and
CONFIG.SYS. Then LOAD_USA loads the image file onto drive C, deleting all
the files currently on drive C.
Here is the syntax for LOAD_USA:
load_usa
Note: If you installed Auto-Loader for a DOS NLS country, the LOAD_USA batch
file is not installed.
helconital
BC
NF
Software Utility Reference
D
D-11
Advertisement
Table of Contents
