Table of Contents
Advertisement
JANUS 2010 Hand-Held Computer User's Manual (4MB)
code39
nugget
SEL (Select) (continued)
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
SOM (Start of Message)
Purpose:
SOM is the first character in a message sent to or received from the host
computer.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
Default:
Disabled
Syntax:
PEdata
where data can be any ASCII character.
To disable SOM, scan this bar code:
Scan:
Disable SOM
*$+PE*
*$+PE*
Or:
To set SOM to an ASCII character:
1. Scan this bar code:
12-90
helconital
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Enter Accumulate Mode / Set SOM
*+/$+PE*
*+/$+PE*
Advertisement
Table of Contents
