Intermec JG2010 User Manual page 140

JANUS 2010 Hand-Held Computer User's Manual (4MB)
4-12
4. Insert the card into the drive slot, connector end first with the single-walled
notch on the right edge of the card.
5. Push the card into the drive slot until it fits firmly in the connector. The
card will click or snap into place when seated correctly.
Note: Do not force a PC card into the drive slot. If the card does not fit easily into
the connector, remove it and make sure you have the card oriented correctly. Then
try again.
Approximately 5 seconds after you insert the card, the reader sounds an
audible beep tone to indicate that it recognizes the card. For a description of
the beep tones, see "Understanding the Reader's Audio Signals" in
Chapter 2.
6. To install the drive door, line up the three tabs on the door with the slots in
the reader. Slide the door into the reader until it snaps into place.
Note: If you are using a card with an external cable, do not install the drive door.
Single-walled
notch
2010U.160