code39
nugget
Disabling or Enabling Command Override and Enter
Purpose:
You can use the Command Processing configuration command to disable or
enable two additional reader commands: Command Override and Enter. You
can also use IC.EXE to disable or enable these two commands. For help, see
Chapter 5, "Configuring the Reader."
Default:
Command Override and Enter enabled
Syntax:
DC<command>data
Acceptable values for data are:
0
1
To disable or enable Command Override, scan one of these bar codes:
Scan:
Disable Command Override
*/D/KDC$P0*
*$+DC<DLE>0*
Enable Command Override
*/D/KDC$P1*
*$+DC<DLE>1*
To disable or enable Enter, scan one of these bar codes:
Or:
Disable Enter
*/D/KDC$M0*
*$+DC<CR>0*
Enable Enter
*/D/KDC$M1*
*$+DC<CR>1*
helconital
Disable command
Enable command
Configuration Command Reference
12
12-33