Intermec JG2010 User Manual page 166

JANUS 2010 Hand-Held Computer User's Manual (4MB)
To create two INI files with different beeper volumes
1. Start IC.EXE, choose the Beeper command from the Op menu, and set the
2. Choose the Save As command from the File
3. Specify a unique DOS filename for the INI
4. Choose Exit from the File menu. This screen prompts you to update the
5. Press
6. Restart IC.EXE, choose Beeper from the Op
7. Choose Save As from the File menu, and
8. Choose Exit from the File menu. Again, IC.EXE prompts you to update the
9. Press
5-10
beeper volume to Quiet.
menu and press . The Configuration
screen appears.
file, such as QUIET.INI. Make sure the
filename includes a path with a drive that
you can write to, such as drive E:
e:\quiet.ini
Note: If you store the configuration file on drive E, the file will be erased when you
cold boot the reader, load flash memory, put the reader in Storage mode, or execute
CONFIG.SYS after changing the command that creates drive E.
online configuration before you exit:
The online configuration (also called the
current configuration) is the set of
parameters currently enabled on the reader.
to choose Yes and apply the
changes to the reader. The reader now beeps
quietly.
menu, and change the beeper volume to
Very Loud.
specify a unique DOS filename for the INI
file, such as VERYLOUD.INI.
online configuration before exiting.
to select No and press
quietly.
Configuration
File
Load...
Load Default
Save
Save As...
About
Exit
Configuration
Update online
configuration?
. The reader is still configured to beep
Sym Com Op
2010U.067
Information
Yes No
Cancel
2010U.107