Detaching/Attaching The Grab Rail Cover (Option); Cleaning - Otto Bock Kimba Neo Instructions For Use Manual

78

6.6.4 Detaching/attaching the grab rail cover (option)

1) Push in the tripod spring and remove the grab rail (see Fig. 80, item 1).
2) Pull the grab rail pad (see Fig. 76, item 3) off the grab rail and clean it.
3) Slide the grab rail pad onto the grab rail (see Fig. 80).
4) Reattach the grab rail.
80

6.7 Cleaning

Cleaning by hand
1) Clean all frame components and plastic parts using mild detergents only.
2) Wash covers made of spacer fabric and microfibre at a maximum temperature of 40 °C. To do this, remove the
covers from the padding and wash the covers only.
INFORMATION: You can wash covers in the washing machine – but only in a laundry bag or pillow
case. However, wiping with a damp cloth is sufficient in most cases.
Important information on cleaning
• Do not use any aggressive cleaners, solvents or hard brushes, etc.
Cleaning in a washing chamber
1) Remove the padding and covers, and follow the washing instructions for each article.
2) Wash the seating unit at max. 60 °C for max. 10 minutes.
3) If necessary: Remove all components where water has accumulated.
4) Allow the seating unit to dry. In order to do so, set the folded rehab buggy vertically onto the back wheels and
push handles so that water can run out (see Fig. 81).
INFORMATION: We recommend drying with compressed air.
5) If necessary: Reinstall all components that were removed.
6) Before storing or using the seating unit again, verify that it is dry. Wipe wet components with a cloth as
needed.
7) Ensure that all labels (nameplate and warnings) are still legible. Otherwise replace these labels.
Kimba Neo
79
Use
Ottobock | 33