Incontinence Cover - Otto Bock Kimba Neo Instructions For Use Manual

62

6.3.10 Incontinence cover

The incontinence cover (see Fig. 63) protects the padding of the Kimba Neo seating unit.
The incontinence cover can be removed for washing. Close the hook-and-loop straps before washing.
63
Attaching the incontinence cover
1) Remove the seat padding and the back padding from the seating unit (see Page 31 et seq.).
2) Lay out the incontinence cover ready for the seat and back padding. To do this, open all the hook-and-loop
straps (see Fig. 64).
3) Place the seat padding in the incontinence cover.
4) Secure the incontinence cover to the back padding:
→ Place the back padding on the incontinence cover (see Fig. 65).
→ Guide the lower 3 hook-and-loop straps around the back padding and strap them together (see Fig. 66,
item 1).
→ Thread the vertical hook-and-loop straps through the back padding (see Fig. 66, item 2).
5) Secure the back padding to the seating unit:
→ Pull the back padding with its cap over the back insert.
→ Guide the vertical hook-and-loop straps towards the rear over or through the back plate (see Fig. 67,
item 1).
→ Guide the upper horizontal hook-and-loop strap around the back plate and strap it together (see Fig. 67,
item 2). In doing so, the vertical hook-and-loop straps must be secured with the horizontal hook-and-loop
strap (see Fig. 67, item 3).
6) Push the back padding towards the rear and secure it to the back of the seating unit with the twist lock.
Kimba Neo
Use
Ottobock | 27