Canopy - Otto Bock Kimba Neo Instructions For Use Manual

Mounting the tray
1) Plug the tray into the adapters.
2) Push in the tripod spring (see Fig. 48, item 1).
3) Press down the tray until the tripod springs lock into place.
Removing the tray
1) Push in the tripod spring (see Fig. 48, item 1).
2) Pull the tray out and up.
Adjusting the tray position
1) Adjust height: loosen the Allen screws on the frame with a size 4 Allen wrench (see Fig. 48, item 2) and adjust
the frame in parallel on both sides. Retighten the Allen head screws.
2) Adjust depth: release the adjustment lever under the tray and set the depth by moving the tray (see Fig. 49,
item 1). Then firmly close the adjustment lever.
3) Adjust the angle: release the adjustment lever under the tray and set the tray angle by turning the tray at the
joint (see Fig. 49, item 2). Then firmly close the adjustment lever.
48

6.3.5 Canopy

CAUTION
Exposed pinch points
Crushing, pinching due to incorrect handling
► When folding out the backrest, only grip by the specified components.
NOTICE
Improper use of the canopy
Damage to the fabric through user error
► Remove the canopy before folding the rehab buggy.
► Remove the canopy from the rehab buggy if it is stored for a long period to protect it from damage.
The rehab buggy can be equipped with a canopy to protect the user from sun or rain (see Fig. 50).
Mounting the canopy
1) Move the backrest to an upright position.
2) Move the locking tongues for the canopy into parallel mounting position (see Fig. 55).
3) Press the locking tongues for the canopy into the buckles (see Fig. 55, item 1) until they click into place audibly
(see Fig. 55, item 2).
Adjusting the canopy angle
1) Fold up the canopy.
2) Hold the canopy at the front support and change the angle by pressing or pulling on the support. The setting
joint locks into place automatically (see Fig. 55, item 3).
Removing the canopy
1) Move the backrest to an upright position.
Kimba Neo
49
Use
Ottobock | 23