Use; Information On Use - Otto Bock Kimba Neo Instructions For Use Manual

Mounting the seat
1) Place the seat on the rear tube of the seat adapter at an angle of approximately 45° (see Fig. 3).
2) Press the front edge of the seat onto the mobility base until the gripper jaw audibly snaps on to the front tube of
the seat adapter (see Fig. 4).
3) Slide the seat lock to the left to engage it (see Fig. 5).
4) Check that the seat and the mobility base are securely connected. You can do this, for example, by pulling
back the backrest.
3
5

6 Use

6.1 Information on use

WARNING
Independent modification of settings
Serious injuries to the user due to unallowable changes to the product
► Do not modify the settings established by the qualified personnel. Only the settings described in the section
"Usage" in these instructions for use may be adjusted independently.
► In case of problems with the settings (unsatisfactory seating position, front wheels wobble, etc.) please con­
tact the qualified personnel who adjusted your product.
► Discuss all changes to the settings with the qualified personnel/therapist in advance in order to minimise
health hazards and avoid putting the therapy results at risk.
WARNING
Impermissible use
Tipping over, rolling over of the user due to failure to observe specifications
► Using a rehab buggy beyond normal conditions may be dangerous.
► Do not exceed the maximum load capacity (see the section "Technical Data").
Kimba Neo
4
Use
Ottobock | 9