Tone Scan Function - Icom IC-F29DR3 Operating Instructions Manual

4
ADVANCED OPERATION

Tone Scan function

This function is effective when the user wants to
communicate with another station but does not know
its CTCSS tone or DTCS code setting.*
* Depending on the presetting. Ask your dealer for
details.
NOTE: Turn ON the Beep function (p. 16) before
you enter the Tone Scan mode.
1. Rotate [VOL] to turn OFF the power.
2. Set [Rotary Selector] to any channel other than
Channel 16.
3. While holding down [Upper] and [Lower], rotate
[VOL] to turn ON the transceiver and enter the
Tone Scan mode.
• An opening beep sounds and the current channel
number is announced. (Example: Ten)
4. Rotate [Rotary Selector] to select a desired
channel that you want to assign the detected
CTCSS tone or DTCS code to.
• The selected channel number is announced.
5. Hold down [Upper] for 1 second to start a scan.
• The status indicator blinks green slowly.
6. When detecting a matching tone or code, the scan
pauses, and the tone or code is automatically set
to the channel.
7. Push [Upper] to cancel the scan.
NOTE: The scan resumes 3 seconds (default) after
the signal disappears.
8. Rotate [VOL] to turn OFF the transceiver and exit
the Tone Scan mode.
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com
[Rotary Selector]
[PTT]
[Upper]
[Lower]
15
[VOL]