Removing And Fastening The Back Support Pad - Otto Bock Motus CV Instructions For Use Manual

Use
1) Lay the seat cushion onto the seat upholstery and secure it against sliding by pressing it onto the hook-and-
loop fastener (see fig. 61).
2) To remove, detach the seat cushion from the hook-and-loop closure on the seat upholstery.
61

9.4.2 Removing and fastening the back support pad

The back padding can be removed from the wheelchair for cleaning.
Removing the back support pad
1) Remove the seat cushion.
2) Pull the flap of the back support pad off the seat upholstery (see fig. 62).
3) Pull the back support pad off the hook-and-loop straps of the back support upholstery (see fig. 63).
Fastening the back support pad
1) From the rear, apply the edge of the back support pad to the upper hook-and-loop strap (see fig. 64).
2) Fold down the back support pad and secure it to the upholstery straps with the hook-and-loop fasteners (see
fig. 63).
3) Pull the part of the flap that can be fastened forward and attach it to the seat upholstery with the hook-and-loop
fastener (see fig. 62).
62
36
63
Motus CV, Motus CS