Otto Bock Motus CV Instructions For Use Manual page 54

Use
107
Information on correct transport safety of the user in the vehicle for transporting persons with reduced
mobility
• Please also observe the section "General information on correct transport safety of the user in the vehicle for
transporting persons with reduced mobility".
• Using the personal restraint system of the vehicle for transporting persons with reduced mobility is required. If
the wheelchair is equipped with a fixation kit (anchor point adapters), the three-point personal restraint system
is attached in the vehicle for transporting persons with reduced mobility as follows:
– The lap belt of the personal restraint system is usually attached by the qualified personnel to the left and
right sides respectively on the mounting point/pin of the anchor point adapters.
– The shoulder harness of the personal restraint system is usually mounted on the vehicle pillar and is
attached by the qualified personnel to the corresponding mounting point/pin provided on the lap belt.
Placement of the personal restraint system integrated in the vehicle for transporting persons with
reduced mobility
1) Pull the respective ends of the restraint lap belt from the inner side of the seat through to the outside.
2) Engage the ends of the restraint lap belt on the respective mounting point/pin of the anchor point kit (Motus
CV: see fig. 109; Motus CS: see fig. 110).
3) Secure the shoulder harness on the mounting point/pin provided on the lap belt (not illustrated).
→ The restraint lap belt is pulled through and fastened.
→ The belt runs between the side panel and seat cushion on each side.
109
9.20.2.2 Use with belt loops
Securing the product in the vehicle for transporting persons with reduced mobility
The wheelchair is secured in the vehicle for transporting persons with reduced mobility with the help of four belt
loops, on which the vehicle side wheelchair restraint belts are attached.
The fixation points of the belt loops are marked with stickers (pattern). These stickers show where the user has to
pass the belt loops around the frame tube:
54
108
110
Motus CV, Motus CS