Adjusting The Posterior Lower Leg Pad On The Elevating Leg Support; Adjusting The Side Panels - Otto Bock Motus CV Instructions For Use Manual

Settings and assembly instructions
"Segmented, angle-adjustable" leg support
1) Loosen the Allen head screws on the foot plate (see fig. 39, item 1).
2) Turn the foot plate to the desired angle (see fig. 39, item 2).
3) Tighten the Allen head screws to 6 Nm.
"Angle-adjustable" leg support
1) Loosen the Allen head screws on the rear foot plate suspension by several turns (see fig. 40, item 1).
2) Turn the foot plate to the desired angle (see fig. 40, item 2).
3) Tighten the Allen head screws to 10 Nm.
"Elevating" leg support
Further information: see Page 35.
39

7.8.3 Adjusting the posterior lower leg pad on the elevating leg support

The posterior lower leg pad on this leg support is height-adjustable.
1) Loosen the clamping unit mounting screw (see fig. 41).
2) Slide the posterior lower leg pad to the desired height.
3) Re-tighten the mounting screw.
41

7.9 Adjusting the side panels

"Standard" side panel; "clothing guard" side panel; "carbon standard" side panel
► Adjusting to modified drive wheel position: The adjustment is performed by moving the mounting screws in
the hole matrix of the side panel (illustration shows standard side panel: see fig. 42; see fig. 43). Adjust the
height so the top edge is about 25 mm higher than the wheel surface to prevent the fingers from becoming
pinched.
28
40
Motus CV, Motus CS