Changing The Installation Position Of The Caster Wheels - Otto Bock Motus CV Instructions For Use Manual

Settings and assembly instructions
17
19

7.4.2 Changing the installation position of the caster wheels

The seat height/angle can be subsequently adjusted by changing the position of the casters in the caster forks or
using different wheel sizes.
Please refer to the installation matrix in the section "Technical data" for permitted positions and combinations of
drive wheels and caster wheels.
1) Loosen the screw connection on the threaded axle (see fig. 21, item 1).
2) Remove the screw/threaded sleeve, spacers and (if applicable) nuts.
3) Remove the caster wheel.
4) Insert the screw/threaded sleeve with the first spacer bushing offset in one of the 4 holes (see fig. 22, item 1).
5) Install the caster wheel.
6) Slide on the second spacer bushing (not pictured).
7) Tighten the screw/nut to 8 Nm.
→ Once changed, the left and right caster wheels must have the same vertical position in the caster fork.
→ Once the front seat height has been adjusted, the caster journal angle must be checked and if necessary read­
justed.
21
22
18
20
22
Motus CV, Motus CS