Adjusting The Lap Belt; Delivery; Final Inspection - Otto Bock Motus CV Instructions For Use Manual

Delivery

Anti-tipper height adjustment
1) Remove the Allen head screw between the anti-tipper tube and the adapter tube (see fig. 46, item 1).
2) Adjust the height of the anti-tipper by sliding it in the adapter tube (see fig. 46, item 2).
→ The distance between the anti-tipper rollers and the ground must be 50 mm max. (not illustrated).
3) Tighten the screws for the anti-tipper.
Anti-tipper length adjustment
1) Press the push-button on the lower tube section of the anti-tipper (see fig. 47, item 1).
2) Adjust the length of the anti-tipper (see fig. 47, item 2):
→ As a minimum, the anti-tipper rollers must project fully beyond the largest diameter of the drive wheel (not
illustrated).
3) Allow the push-button to engage.
46

7.11 Adjusting the lap belt

CAUTION
Incorrect approach to the adjustment process
Injuries, malpositions, user discomfort due to adjustment errors
► The qualified personnel is responsible for the individual positioning and fitting of the belt system.
► Adjusting the belt system too tightly may lead to unnecessary pain or user discomfort.
► Adjusting the belt system too loosely can cause the user to slide into a dangerous position. In addition, the
fastening snaps could open unintentionally if they slide against hard parts of clothing (e.g. buttons).
CAUTION
Lack of instruction
Injuries, malpositions, illness of the user due to incorrect information
► The qualified personnel is responsible for making sure that the user and/or attendant/nursing staff has under­
stood the proper adjustment, use, maintenance and care of the belt system.
► In particular, ensure that the user and/or attendant/care staff knows how to quickly loosen and open the
product to avoid delays in case of emergency.
Information on the settings can be found in the manufacturer's instructions for use accompanying each product.
8 Delivery

8.1 Final inspection

A final check must be carried out before the wheelchair can be handed over:
• Are the drive wheels correctly positioned?
• Do the quick-release axles rotate freely and lock securely?
• Have the tyres been correctly inflated?
INFORMATION: The correct tyre pressure is printed on the tyre sidewall. For drive wheels with high-
pressure tyres, the minimum air pressure is 7 bar.
• Only after adjustment: Have the brakes (wheel locks) been adjusted correctly?
30
47
Motus CV, Motus CS