Adjusting The Back Support Angle; Adjusting The Back Support Upholstery / Seat Upholstery; Adjusting The Back Support Upholstery - Otto Bock Motus CV Instructions For Use Manual

Hide thumbs Also See for Motus CV:

Table of Contents

2) Remove all screws from the rear frame tube, including the screw connections of the drive wheel adapter (see

fig. 29).

3) Slide both back tubes to the desired height. Both back tubes must be set to the same height.

4) Insert the screws into the rear frame tube and tighten to 8 Nm.

In doing so, slide the back tube at least 79 mm into the frame tube and always mount it with 2 screws.

7.6.2 Adjusting the back support angle

WARNING

Missing anti-tipper

Tipping over, falling of the user due to missing safety devices

► If the back is tilted far to the rear and in the case of a short wheelbase, 2 anti-tippers (one on each side) must

be mounted and in a functional position; in the case of a long wheelbase, at least one anti-tipper must be

mounted and in a functional position.

► Check that the anti-tipper is securely attached.

With the "30° back angle adjustment" option, the backrest angle can be adjusted from 90° to 120° (see Page 37).

INFORMATION

A well-adjusted back support provides lasting comfort for the wheelchair user and reduces the risk of secondary

damage and pressure zones. Do not create too much pressure.

INFORMATION

Ensure that the user's pelvis is positioned as far back in the wheelchair as possible, i.e. between the back tubes.

The adjustable back support upholstery can be adapted in segments to the needs of the user.

1) Remove the seat cushion.

2) Pull the back support pad up and off the hook-and-loop fastener on the back support upholstery.

3) Loosen the back support straps and then fasten them together with the desired tension (see fig. 30, see

fig. 31).

4) Put on the back support pad and attach it to the hook-and-loop fastener on the back support upholstery.

5) Put on the seat cushion and secure it with the hook-and-loop fastener.

Motus CV, Motus CS

Settings and assembly instructions

Table of Contents

Motus cs