Adjusting The Back Support Angle; Folding Down The Back Support; Removing And Fastening The Back Support Pad - Otto Bock Start Multi Instructions For Use Manual

Use
CAUTION
Pinching on components
Crushing and pinching of fingers due to lack of caution in danger areas
► Do not reach between the moving frame components when adjusting the back angle.

9.5.1 Adjusting the back support angle

1) Hold the push handles firmly.
2) Activate and hold the release lever on the right push handle (see fig. 54, item 1).
→ The locking mechanism is released.
3) Move the back support to the desired angle by moving the push handles (see fig. 55).
4) Let go of the release lever.
→ The back support is secured at the desired angle.
54

9.5.2 Folding down the back support

The backrest can be folded down for stowing or transportation.
1) CAUTION! Hold the back support when removing the locking bolt and secure the gas compression
spring against falling. Get a second person involved if necessary. Remove the locking bolt on the gas
compression spring connection (see fig. 56, item 1).
2) Fold the back support forward onto the seat (see fig. 57).
56

9.5.3 Removing and fastening the back support pad

Removing and fastening the back support pad
The back support pad can be removed for cleaning:
1) Carefully pull the back support pad off the hook-and-loop closure on the back support (see fig. 58, item 1).
2) After cleaning (see page 47): Put the back support pad onto the back support. Secure the back support pad
against sliding by pressing it onto the hook-and-loop closure.
34
55
57
Start Multi