Removing And Fastening The Seat Cushion; Fastening And Removing The Back Padding - Otto Bock VENTUS Instructions For Use Manual

NOTICE
Wear of the seat and back upholstery
Avoidable loss of functionality due to unallowable continued use
► Have the seat and back upholstery replaced immediately in the event of damage or wear.
The product is equipped with seat and back upholstery. Hook-and-loop fasteners on the seat upholstery are used
to attach the seat cushion. The seat cushion ensures pressure relief during use of the wheelchair. It was chosen by
qualified personnel according to the needs of the user.

6.5.1 Removing and fastening the seat cushion

If the seat upholstery is "adaptable", the seat cushion and seat pad can be removed from the wheelchair for clean­
ing.

6.5.2 Fastening and removing the back padding

The backrest pad (adjustable) can be removed for cleaning.
1) Remove the seat cushion.
2) Fold the seat pad forwards away from the hook-and-loop fastener (see fig. 13, item 1).
3) Pull the flap of the backrest pad off the hook-and-loop fastener (see fig. 13, item 2) and let it hang down.
4) Remove the backrest pad.
5) After cleaning:
→ Put the backrest pad back on. Place the kink in the backrest pad at the top. The "V" in the pad (see fig. 14,
item 1) shows exactly where the kink is.
→ Pull the backrest pad flap tightly downwards (see fig. 15).
→ Pull the part of the flap that can be fastened forwards and fasten tightly to the seat upholstery (see fig. 13,
item 2).
INFORMATION: The part of the flap that can be fastened prevents sliding or falling through the
gaps between the straps and protects against draughts.
6) Fasten the seat pad (see fig. 13, item 1) and the seat cushion.
13
15
Ventus
14
Use
Ottobock | 15