Adjusting The Anti-Tipper - Otto Bock Motus CV Instructions For Use Manual

42
Desk side panel (not illustrated)
1) Adjusting the height of the forearm support: Pull up the release button in the round opening and adjust the
height (see fig. 72).
2) Adjusting the depth of the forearm support: Loosen the mounting screws on the side of the forearm sup­
port, move the forearm support and firmly re-tighten the mounting screws (see fig. 44, item 1).
"Plug-on" side panel
1) Adjusting the height of the forearm support: Use a ballpoint pen or screwdriver to push in the counter-sunk
locking button and slide the side panel to the desired position (see fig. 73).
CAUTION! The locking button is intentionally counter-sunk to prevent accidental operation. Always
use an object to press the locking button, never your fingers.
2) Adjusting the depth of the forearm support: Loosen the mounting screws under the forearm support, move
the forearm support and firmly re-tighten the mounting screws (see fig. 45, item 1).
44

7.10 Adjusting the anti-tipper

WARNING
Incorrect installation of the anti-tipper/missing anti-tipper
Tipping over, falling of the user due to failure to observe the installation instructions and because of incorrect
adjustment
► Depending upon the settings of the chassis, the centre of gravity, the back angle and the experience of the
user, the use of an anti-tipper may be necessary.
► For a small wheelbase and a backrest that is tilted far back, an anti-tipper may need to be installed on both
sides, depending upon the user's experience.
► Verify that the anti-tipper has been installed and adjusted properly. Find the appropriate position with the
assistance of a helper.
INFORMATION
In order to adjust the anti-tipper correctly, it may be necessary to combine the steps to adjust the length and
angle.
Motus CV, Motus CS
Settings and assembly instructions
43
45
29