Otto Bock Motus CV Instructions For Use Manual page 55

Attaching the belt loops
1) Position the product in the vehicle for transporting persons with reduced mobility. For more information, please
refer to section 5 in the brochure "Transporting persons with reduced mobility", order number 646D158.
2) Front fixation points: Attach one belt loop around each of the frame tubes on the left and right, wrapping
them around the frame tubes at the marked position once or twice depending on the length (example: see
fig. 111, item 1).
3) Engage the hook of the respective vehicle side wheelchair restraint belt in the belt loop (see fig. 111, item 2).
4) Rear fixation points: Attach one belt loop around each of the back support tubes on the left and right at the
marked position (example: see fig. 112, item 1).
5) Engage the hook of the respective vehicle side wheelchair restraint belt in the belt loop (see fig. 112, item 2).
6) Tighten the vehicle side wheelchair restraint belts at the front and rear as firmly as possible.
→ The product showing the correct positioning of the attachment straps (see fig. 113).
111
113
Information on correct transport safety of the user in the vehicle for transporting persons with reduced
mobility
• Please also observe the section "General information on correct transport safety of the user in the vehicle for
transporting persons with reduced mobility".
• Using the personal restraint system of the vehicle for transporting persons with reduced mobility is required.
Attaching personal restraint systems of the vehicle for transporting persons with reduced mobility to the wheel­
chair is not permitted. The 3-point restraint has to be realised entirely on the vehicle:
– The lap belt of the personal restraint system is usually attached by the qualified personnel to the left and
right sides respectively on the mounting point/pin of the rear lashing straps (wheelchair restraint belts on
the vehicle bottom).
– The shoulder belt of the personal restraint system is usually mounted on the vehicle pillar and is attached by
the qualified personnel to the corresponding mounting point/pin provided on the lap belt.
Placement of the personal restraint system integrated in the vehicle for transporting persons with
reduced mobility
1) Pull each end of the restraint lap belt from the inner side of the seat through to the outside.
Motus CV, Motus CS
112
Use
55