9.7.2 Removing the push handles
Push handles of the "height-adjustable, removable" type can be removed from the back support tube when
needed.
Removing/installing the push handles
1) Release the clamping lever (see fig. 79, item 1).
2) Push in the tripod spring (see fig. 79, item 2) and pull the push handle up and out of the adapter (see fig. 79,
item 3).
3) To install, push in the tripod spring again and insert the push handle into the adapter.
4) Firmly close the clamping lever (see fig. 79, item 1).
→ Both push handles must be installed at the same height.
79
9.8 Stabiliser bar
The stabiliser bar between the push handles increases the wheelchair's stability, especially in case of high loads
(see fig. 80). It has to be opened before folding the wheelchair.
Please note: Using the stabiliser bar for pushing and pulling the wheelchair is not permitted. Always use the push
handles for this purpose.
Opening the stabiliser bar
1) Open the star handle on the right side (see fig. 81, item 1).
2) Fold the stabiliser bar down (see fig. 81, item 2).
Closing the stabiliser bar
1) Fold the stabiliser bar up until the opening is against the screw of the star handle.
2) Hand-tighten the star handle.
80
Motus CV, Motus CS
81
Use
41