Otto Bock Motus CV Instructions For Use Manual page 19

Position on the drive wheel
adapter
Inside
1) Alignment A: The thicker/heavier side of the camber washer is on top.
2) Alignment B: The thinner side of the camber washer is on top.
9
INFORMATION
► Please be aware that with a larger negative camber the overall width of the wheelchair increases and the drive
wheels are subjected to higher stress.
Adjusting the drive wheel camber
1) Remove the wheels.
2) Loosen the hexagon nut on the inside from the fitting (see fig. 11, item 1) and remove the fitting to the outside.
3) Slide the camber washers onto the quick-release axle receiver bushing according to the table and align them.
4) Slide the fitting back on and tighten the hexagon nut slightly (see fig. 11, item 1). Readjust the toe-in before
tightening (see Page 20).
5) If necessary: The distance between the drive wheel and the side panel can be continuously adjusted by turn­
ing the counter nut.
6) Tighten the hexagon nut and the counter nut on both sides of the fitting to 50 Nm.
INFORMATION: After adjustment, the camber of the left and right drive wheels must have the same
angle.
7) If necessary: Readjust the height and alignment of the caster attachment device as well as the wheel locks
(see information at the start of the section).
11
Motus CV, Motus CS
Drive wheel camber
2.5° (3.5°)
---
10
Settings and assembly instructions
0° (1°)
1x camber washer (see fig. 10,
item 1)
1)
Alignment A
1x camber washer (see fig. 10,
item 2)
2)
Alignment B
19