Restrictions For Use - Otto Bock Motus CV Instructions For Use Manual

Use
2) Engage the ends of the restraint lap belt on the mounting point/pin of the rear lashing straps on the left and
right sides respectively (see fig. 114; see fig. 115).
Alternatively, the end of the restraint lap belt can also be attached on the bottom of the vehicle for transporting
persons with reduced mobility with the help of a belt reel or retractor (seat belt tightener).
3) Secure the shoulder harness on the mounting point/pin provided on the lap belt (not illustrated).
→ The restraint lap belt is pulled through and fastened.
→ The belt runs between the side panel and seat cushion on each side.
114

9.20.3 Restrictions for use

WARNING
Risk of accidents and injury due to using the product with certain settings and/or installed options
Severe injury in case of accidents due to options coming loose
► Before using the product as a seat in a vehicle for transporting persons with reduced mobility, remove options
that need to be taken off for safe transportation. Please observe the following table.
► Stow all dismantled components securely in the vehicle for transporting persons with reduced mobility.
► Please note that certain settings on the product exclude the use of the product in a vehicle for transporting
persons with reduced mobility.
Motus CV; Motus CS
Option 1)
z50, e-Support add-on drive
Crutch holder right/left
Seat width 500 – 535
Wheelbase extension
Back angle adjustment 30°
Back height < 400 mm
Transport wheel
Tray
Lap belt
56
115
Transportation in a Option must be
vehicle for trans­ removed
porting persons
with reduced mobil­
ity not possible
X
X
X
X
X
X
Secure option on
product
X
X
X
Motus CV, Motus CS
2)
3)