Otto Bock Axon-Bus Instructions For Use Manual page 33

5 Scope of Delivery and Accessories
5.1 Scope of delivery
The product is delivered preinstalled. The scope of delivery includes:
• 1 pc. Axon-Bus prosthetic system
• 1 pc. 757L500 AxonCharge Integral
• 1 pc. Instructions for use (user)
5.2 Accessories
The following components are not included in the scope of delivery and may be ordered separ­
ately:
• 4X500 AxonCharge Mobile
• 757S500=* AxonCharge adapter
6 Charging the battery
The following points must be observed when charging the battery:
• The capacity of a fully charged battery is sufficient for one full day.
• We recommend charging the product every day when used on a daily basis.
• The battery should be charged for at least 3 hours prior to initial use.
• Use the 757L500 battery charger to charge the battery.
6.1 Connecting the power supply and battery charger
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see
fig. 1).
2) Connect the round plug of the power supply to the receptacle on the battery charger so that
the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Plug the power supply unit into the wall socket.
6.2 Connect battery charger to the product
6.3 Display of the current charge level
Power supply and battery charger operating states
During the charging process, the current battery charge level (Status signals) is indicated by the
LEDs on the battery charger lighting up in sequence (see fig. 3, items 2-5).
Displaying the charge level on the product
The battery charge level can be queried at any time.
1) With the prosthetic system switched on, press the charging receptacle button and hold for
less than one second.
2) The LED display on the charging receptacle provides information on the current battery
charge level (Status signals).
1) Connect the charging plug to the charging receptacle of the
product.
→ The correct connection of the battery charger to the product is
indicated by feedback (see page 43).
2) The charging process starts.
→ The Axon-Bus prosthetic system is switched off automatically.
3) Disconnect the product after the charging process is complete.
33