Configuring Tacacs+ Settings For A User Group - Cisco 3.3 User Manual

Chapter 6 User Group Management
Step 6
Step 7

Configuring TACACS+ Settings for a User Group

Note
Step 1
Step 2
Step 3
Step 4
78-16592-01
To save the group settings you have just made, click Submit.
For more information, see
To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Perform this procedure to configure and enable the service/protocol parameters to
be applied for the authorization of each user who belongs to the group. For
information on how to configure settings for the Shell Command Authorization
Set, see Configuring a Shell Command Authorization Set for a User Group,
page 6-33.
To display or hide additional services or protocols, click Interface
Configuration, click TACACS+ (Cisco IOS), and then select or clear items in the
group column, as applicable.
To configure TACACS+ settings for a user group, follow these steps:
In the navigation bar, click Group Setup.
The Group Setup Select page opens.
From the Group list, select a group, and then click Edit Settings.
The Group Settings page displays the name of the group at its top.
From the Jump To list at the top of the page, choose TACACS+.
The system displays the TACACS+ Settings table section.
To configure services and protocols in the TACACS+ Settings table to be
authorized for the group, follow these steps:
Select one or more service/protocol check boxes (for example, PPP IP or
a.
ARAP).
Under each service/protocol that you selected in Step a, select attributes and
b.
then type in the corresponding values, as applicable, to further define
authorization for that service/protocol.
Configuration-specific User Group Settings
Saving Changes to User Group Settings, page
User Guide for Cisco Secure ACS for Windows Server
6-56.
6-31