Cisco 3.3 User Manual page 235

For windows server version 3.3
Table of Contents

Advertisement

Chapter 6
User Group Management
Cisco VPN 3000 Concentrator RADIUS represents only the Cisco VPN 3000
Concentrator VSA. You must configure both the IETF RADIUS and Cisco VPN
3000 Concentrator RADIUS attributes.
To hide or display Cisco VPN 3000 Concentrator RADIUS attributes, see
Note
Protocol Configuration Options for Non-IETF RADIUS Attributes, page
VSA applied as an authorization to a particular group persists, even when you
remove or replace the associated AAA client; however, if you have no AAA
clients of this (vendor) type configured, the VSA settings do not appear in the
group configuration interface.
To configure and enable Cisco VPN 3000 Concentrator RADIUS attributes to be
applied as an authorization for each user in the current group, follow these steps:
Confirm that your IETF RADIUS attributes are configured properly.
Step 1
For more information about setting IETF RADIUS attributes, see
IETF RADIUS Settings for a User Group, page
In the navigation bar, click Group Setup.
Step 2
The Group Setup Select page opens.
From the Group list, select a group, and then click Edit Settings.
Step 3
The Group Settings page displays the name of the group at its top.
From the Jump To list at the top of the page, choose RADIUS (Cisco VPN 3000).
Step 4
In the Cisco VPN 3000 Concentrator RADIUS Attributes table, determine the
Step 5
attributes to be authorized for the group by selecting the check box next to the
attribute. Further define the authorization for that attribute in the field next to it.
For more information about attributes, see
the documentation for network devices using RADIUS.
To save the group settings you have just made, click Submit.
Step 6
For more information, see
To continue specifying other group settings, perform other procedures in this
Step 7
chapter, as applicable.
78-16592-01
Configuration-specific User Group Settings
Appendix C, "RADIUS
Saving Changes to User Group Settings, page
User Guide for Cisco Secure ACS for Windows Server
Configuring
6-38.
Attributes", or
Setting
3-17. A
6-56.
6-45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Secure access control serverSecure acs

Table of Contents