Advanced User Authentication Settings
Step 1
Step 2
Step 3
Step 4
Advanced User Authentication Settings
User Guide for Cisco Secure ACS for Windows Server
7-22
To assign a downloadable IP ACL to a user account, follow these steps:
Perform Step 1 through Step 3 of
The User Setup Edit page opens. The username being added and edited is at the
top of the page.
Under the Downloadable ACLs section, click the Assign IP ACL: check box.
Select an IP ACL from the list.
Do one of the following:
If you are finished configuring the user account options, click Submit to
•
record the options.
To continue to specify the user account options, perform other procedures in
•
this chapter, as applicable.
This section presents the activities you perform to configure user-level TACACS+
and RADIUS enable parameters.
This section contains the following topics:
TACACS+ Settings (User), page 7-23
•
Configuring TACACS+ Settings for a User, page 7-24
–
Configuring a Shell Command Authorization Set for a User, page 7-26
–
Configuring a PIX Command Authorization Set for a User, page 7-29
–
Configuring Device-Management Command Authorization for a User,
–
page 7-30
Configuring the Unknown Service Setting for a User, page 7-32
–
Advanced TACACS+ Settings (User), page 7-33
•
Setting Enable Privilege Options for a User, page 7-33
–
Setting TACACS+ Enable Password Options for a User, page 7-35
–
Setting TACACS+ Outbound Password for a User, page 7-37
–
Chapter 7
Adding a Basic User Account, page
User Management
7-4.
78-16592-01