Action Codes For Modifying Network Configuration - Cisco 3.3 User Manual

Appendix F RDBMS Synchronization Import Definitions
Table F-5 Action Codes for Modifying TACACS+ and RADIUS Group and User Settings (continued)
Action
Code Name
178 SET_PERMIT_DENY_
UNMATCHED_IOS_
COMMANDS
179 REMOVE_ALL_IOS_
COMMANDS
210 RENAME_GROUP
211 RESET_GROUP
212 SET_VOIP

Action Codes for Modifying Network Configuration

78-16592-01
Required
UN|GN, V1 Sets unmatched Cisco IOS command behavior. The
UN|GN
GN,V1
GN
GN, V1
Table F-6 lists the action codes for adding AAA clients, AAA servers, network
device groups, and proxy table entries. Transactions using these codes affect the
configuration displayed in the Network Configuration section of the HTML
interface. For more information about the Network Configuration section, see
Chapter 4, "Network Configuration".
Description
default is that any Cisco IOS commands not defined
via a combination of Actions 174 and 175 will be
denied. This behavior can be changed so that issued
Cisco IOS commands that do not match any
command/command argument pairs are authorized:
GN = "Group 1"
V1 = "permit"
or
UN = "fred"
V1 = "deny"
The first example will permit any command not
defined by Action 174.
This action removes all Cisco IOS commands defined
for a particular user or group.
Renames an existing group to the name supplied in
V1.
Resets a group back to the factory default.
Enables or disables Voice over IP (VoIP) support for
the group named, as follows:
GN = name of group
•
V1 = ENABLE or DISABLE
•
User Guide for Cisco Secure ACS for Windows Server
Action Codes
F-25