Chapter 4
Network Configuration
Deleting a AAA Client
Step 1
Step 2
Step 3
Step 4
AAA Server Configuration
78-16592-01
To delete a AAA client, follow these steps:
In the navigation bar, click Network Configuration.
The Network Configuration page opens.
Do one of the following:
If you are using NDGs, click the name of the NDG to which the AAA client
•
is assigned. Then, click the AAA client hostname in the AAA Clients table.
To delete a AAA client when you have not enabled NDGs, click the AAA
•
client hostname in the AAA Clients table.
The AAA Client Setup for the Name page appears.
To delete the AAA client and have the deletion take effect immediately, click
Delete + Restart.
Restarting Cisco Secure ACS services clears the Logged-in User report
Note
and temporarily interrupts all Cisco Secure ACS services. As an
alternative to restarting when you delete a AAA client, you can click
Delete. However, when you do this, the change does not take effect until
you restart the system, which you can do by clicking System
Configuration, clicking Service Control, and then clicking Restart.
A confirmation dialog box appears.
Click OK.
Cisco Secure ACS restarts AAA services and the AAA client is deleted.
This section presents procedures for configuring AAA servers in the Cisco Secure
ACS HTML interface. For additional information about AAA servers, see
Servers in Distributed Systems, page
4-3.
User Guide for Cisco Secure ACS for Windows Server
AAA Server Configuration
AAA
4-21