User Authentication - W&H Lara RIS-311 Instructions For Use Manual

Hide thumbs Also See for Lara RIS-311:

Table of Contents

CONNECT TO A NETWORK

If you connect through an Ethernet cable, in most cases the sterilizer

will connect to the network automatically. If it does not connect

automatically, or if you are using a Wi-Fi dongle key, follow the

following procedure under supervision of your IT manager / network

administrator.

On the homepage, tap

If the connection is through the Ethernet cable, tap

TCP/IP screen appears.

If the connection is through Wi-Fi dongle key, tap

while, the sterilizer shows the available networks found. Choose

the network, enter the credentials in the further screen, then

tap

to confirm: the TCP/IP screen appears.

Note: the

and

icons are disabled if the connectivity means

(cable or Wi-Fi dongle key) are not properly plugged.

Note: in the TPC/IP screen, the

any change. The Wi-Fi icon at the bottom isn't visible if you connect

through Ethernet cable.

If your network supports dynamic IP addresses (ask your

IT manager), enable the options Dynamic both in IP

Configuration and in the DNS Configuration fields, then tap

to confirm: all entry fields are disabled.

If your network does not support dynamic IP addresses (ask

your IT manager), enable the options Static both in IP

Configuration and in the DNS Configuration fields. Tap on

each entry field and enter the IP addresses (ask your IT

manager for details). Then tap

Lara XL | Instructions for Use | RIS-311 ENG Rev02 | 01/06/2022 | © W&H Sterilization Srl

: the

: after a

icon is visible only if you make

to confirm.