Table of Contents
Advertisement
On the homepage, tap the cycle and
1
Tap the leaf icon to set the ECO DRY mode.
2
Tap the ECO DRY mode you desire.
3
Tap
to confirm and go back to the previous page.
4
To change the start time, tap Start cycle at.
5
Tap the time or the date: a settings page opens.
6
Tap the number you want to change and tap
7
increase it or decrease it.
Tap
to confirm and go back to the previous page. This date
8
and time become the scheduled default start time for all next
sterilization cycles.
Tap
to lock the door and start the countdown for the
9
current cycle.
Note: You can decide to start the cycle immediately or stop the
countdown at any time.
PROGRAM A SEQUENCE OF CYCLES TO RUN AUTOMATICALLY
It is possible to program the sterilizer in such a way that a sequence
of cycles runs automatically at a preset date and time (e.g. if you
want to run a vacuum test plus a HELIX test in the early morning
before office hours). Maximum two cycles can be programmed.
Lara XL | Instructions for Use | RIS-311 ENG Rev02 | 01/06/2022 | © W&H Sterilization Srl
.
or
to
To program the sterilizer proceed as follows:
Load the chamber and close the chamber door.
1
On the homepage, tap
2
Tap
to add a cycle to the list above.
3
Tap
and then the cycle you want to add.
4
Tap
: the cycle is automatically listed in the previous page.
5
Tap the date/time to set the start of the cycle.
6
Tap the number you want to change and tap
7
increase it or decrease it.
Tap
to confirm and go back to the previous page.
8
Repeat steps from 3 to 7 to add another cycle to the
9
sequence.
Tap
to launch the programmed sequence.
10
DELETE A CYCLE FROM A PROGRAMMED SEQUENCE
On the homepage, tap
1
Tap the cycle you want to remove from the sequence.
2
Tap
to remove the selected cycle.
3
Tap
to confirm and go back to the previous page.
4
Sterilization cycles
>
>
>
or
to
>
>
>
55
Advertisement
Table of Contents
