Table of Contents
Advertisement
PRINT LABELS FOR A SPECIFIC CYCLE
Note: Function available only with the Label printer activation code.
On the homepage, tap
1
Scroll the list and tap the desired sterilization cycle: the report
2
opens.
Tap
.
3
Tap
to print traceability labels for the selected cycle.
4
Tap
or
to increase or decrease the number of label to be
5
printed.
Tap
to save the set number for the next time.
6
Tap
to print the labels required.
7
SAVE ALL THE CYCLE REPORTS ON THE USB PEN DRIVE
The number of reports that can be saved on the USB pen drive
depends upon the USB capacity. To save all the cycle reports:
On the homepage, tap
1
Tap
: after the confirmation all sterilization cycle reports are
2
stored in the USB.
Lara XL | Instructions for Use | RIS-311 ENG Rev02 | 01/06/2022 | © W&H Sterilization Srl
>
>
SET THE REMOTE FOLDER FOR SAVING THE REPORTS
To activate the remote storage and set the necessary parameters do
the following:
On the homepage, tap
1
Tap
to enable the remote data storage: the first four
2
fields in the page and the check box turn dark grey.
In Path enter the name of the shared folder followed by the
3
sub-folder name, if any, where to save reports. Do not enter the
full path.
Note: The folder name must include letters and numbers only. Do not
use other characters like space-bar, slash, accent, etc.
Enter the host name or the IP address: if the data are complete,
4
the fields highlight.
Not mandatory. Enter the domain name.
5
Tap
to require the authentication credentials to access the
6
remote storage folder and enter the user name and password.
Tap
to save.
7
Tap
to go back to the previous page.
8
To check if the parameters entered are valid, see "Test the data
9
storage " on the next page.
Sterilization cycles
>
>
>
59
Advertisement
Table of Contents
