Fuse Protection - Beckhoff XTS Operating Instructions Manual

Electrical installation
Painted surfaces
8.4.1
Unpainted surfaces
8.4.2

Fuse protection

8.5
130 ───
8.4.1
► Ground the painted surface with spring washer [1], washer [2],
contact washer [3], nut [4] and screw [5]
8.4.2
► Ground the unpainted surface with spring washer [1], washer [2],
nut [3] and screw [4]
Ensure adequate fuse protection is provided for the power
supply units
If power supply units other than those recommended in this chapter
are used, this should be reflected in the fuse dimensioning. Note
that the selected fuse can be triggered at a higher current than
16 A with the power supply unit used. Follow the documentation of
the power supply unit manufacturer.
Failure to do so may damage the system in the event of a short cir-
cuit.
XTS Version: 3.1