Mounting The Modules - Beckhoff XTS Operating Instructions Manual

Mounting the modules

7.2
Module with power supply
7.2.1
Module with connector
7.2.2
Version: 3.1
Once all modules have been prepared, they are mounted on the
machine bed in the following order.
The installation of the first module depends on whether you are us-
ing a module with a power supply or a module with a connector:
7.2.1
► Position the module [1] with the locating pins [2] in the elongated
holes of the machine bed [3]
► Make sure that the cables [4] are positioned in the recess [5] of
the machine bed
► Hand-tighten the screw [1] with the washer [2] in the center of
the module [3]
► Make sure that the module [3] is slightly movable in the slots
Limited number of turns
The connector may be rotated up to ten times through 180° to bring
it into a safe latching position.
If you turn the connector more than ten times, the cables inside and
the latching mechanism of the connector may be damaged, possi-
bly preventing the connector from assuming a safe latching posi-
tion.
The module connector may be turned a maximum of ten times by
180°.
XTS
Mechanical installation
─── 93