Roller Replacement At At9014-0070-X550 - Beckhoff XTS Operating Instructions Manual

Maintenance work on the mover
Roller replacement at
11.5
AT9014-0070-x550
Scope of supply
11.5.1
Number Name
1 Shoulder bolt M4 x 20
2 Cylindrical roller* 22 mm
3 Adjusting washers 4 x 8 x 1 A2 DIN‑988
4 Nut M4 A2 DIN-6923
5 cover cap
6 Bearing pin D5 x 23
7 Set screw M3 x 6
8 Cylindrical roller* 25 mm
* The rollers [2] and [8] each consist of two ball bearings and a roller lining
172 ───
Dedicated roller sets are available for maintenance of the XTS
mover AT9014‑0070‑x550. A roller set contains all the components
required for replacement.
One time roller replacement
To ensure high availability of the system, the rollers of the
AT9014-0070-x550 mover may only be replaced once. Instead of a
second roller replacement, the entire mover must be replaced.
To replace the guide rollers on the AT9014-0070-x550, you will
need a roller set with order number ZX9014-0070.
Check missing or damaged parts
Check your delivery for completeness. If any parts are missing or
became damaged during transport, contact the carrier, vendor or
our service department immediately.
In roller set ZX9014-0070 the guide rollers are not pre-assembled
and must be sorted according to their color assignment and position
before assembly in accordance with the following figure:
XTS
Number of
items
Version: 3.1
4
4
4
4
8
2
2
2