Specifications; Environmental Conditions; Electrical Specifications; Calibration Ranges - Novanta ATI Axia80 Manual

Manual, F/T Sensor, Axia80
Document #9620-05-B-Axia80-02

7. Specifications

Some requirements and specifications for the Axia80 sensor are covered in the following sections. For more
information, refer to the customer drawing.

7.1 Environmental Conditions

Storage Temperature, °C
Operating Temperature, °C
7.2 Electrical Specifications
Power Source
DC Power
Notes:
The power supply input is reverse polarity protected. If the power and ground to the power supply
1.
inputs are plugged in reverse, then the reverse polarity protection stops the incorrectly wired supply
input from damaging or powering on the sensor.

7.3 Calibration Ranges

Parameter
Calibration Range 0 (SI-150-8)
Calibration Range 1 (SI-75-4)
Notes:
Each sensor is calibrated with both of these calibration ranges.
1.
Parameter
Calibration Range 0 (SI-500-20)
Calibration Range 1 (SI-200-8)
Notes:
Each sensor is calibrated with both of these calibration ranges.
1.
Parameter
Calibration Range 0 (SI-1500-50)
Calibration Range 1 (SI-480-20)
Notes:
Each sensor is calibrated with both of these calibration ranges.
1.
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel:+1 919.772.0115 • Fax:+1 919.772.8259 •
Table 6.1—Environmental Conditions
Parameter
Relative Humidity
Table 6.2—Power Supply
Minimum
12 V
Table 6.3
—Calibration Range 0 and Calibration Range 1
Model
Table 6.4
—Calibration Range 0 and Calibration Range 1
Model
Table 6.5
—Calibration Range 0 and Calibration Range 1
Model
<95%, non-condensing
1
Voltage
Nominal Maximum
24 V 30 V
Axia80-M8
Fxy
150 N
75 N
Axia80-M20
Fxy
500 N
200 N
Axia80-M50
Fxy
1200 N
480 N
B-29
Value
-20 to +85
0 to +65
Power Consumption
Maximum
1.5 W
Txyz
Fz
470 N 8 Nm
235 N 4 Nm
Txyz
Fz
900 N 20 Nm
360 N 8 Nm
Txyz
Fz
2000 N 50 Nm
800 N 20 Nm
www.ati-ia.com