Console "Cal" | "Set" Command Fields And Values - Novanta ATI Axia80 Manual

Manual, F/T Sensor, Ethernet Axia
Document #9620-05-C-Ethernet Axia-02
Command
SAVEALL
STATUS
VIEW
DIAG

8.3 Console "CAL" | "SET" Command Fields and Values

The "set" command reports all settings. Note that "CAL" is synonymous for "set", but in this manual, the
command is referenced to as "set". Many settings are read-only fields that are configured onto the sensor
during ATI factory calibration. All setting fields are listed in
"set" command format, for example:
user:
response:
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel:+1 919.772.0115 • Fax:+1 919.772.8259 •
Operand(s)
Not Applicable
Not Applicable
no operand
0
1
A
Not Applicable
set
Field
-----
serialNum
partNum
calFamily
...
Table 8.1—Commands
Description
This command records all values that
remain through a power cycle to NVM.
If there could be an underlying problem
within the sensor hardware, the "status"
command can be used to retrieve
detailed information or for a user to send
the information to ATI for troubleshooting.
The "status" command reports various
components of the sensor. The content of
this command varies among sensors.
The "view" command reports properties
such as the F/T part number, units,
calibration date, and calibration family.
If a user sends this command without an
operand, all calibrations are reported.
Calibration 0
Calibration 1
Active calibration
The diagnostic status command provides
a report for each of the gages within the
sensor. Compare this information to the
values in the applicable sensor manual;
refer to
command, for troubleshooting.
The report includes the following: gage
number, gage readings in counts, gage
status indicator, F/T axis, F/T reading in
units, all-time peak data, and the active
tool transformation.
Table 8.2.
Value
-----
FT22835
SI-150-8
Ethernet
C-58
Table 2.1. Use the "status"
www.ati-ia.com