F/T Configurations Page (Config.htm - Novanta ATI Axia80 Manual

Manual, F/T Sensor, Ethernet Axia
Document #9620-05-C-Ethernet Axia-02
6.6 F/T Configurations Page (config.htm)
On the Configurations page, a user may select the active calibration and tool transformation settings for
the sensor system. When a user clicks the Apply button, the changes on this page are implemented on the
sensor. For more information about a sensor's calibration ranges and the concept of the tool transformation
feature, refer to the applicable manual in
From the Configurations page, a user may obtain the following values: the sensor's Serial Number, Part
Number, calibration Family, Time or date the sensor was calibrated, force units, torque units, counts per
force, and counts per torque. Note that these are the same values that are in
"SET" Command Fields and Values
For more information about how F/T values are scaled with the counts per force and counts per torque, refer
to Section 8.4.1—Converting Counts Per Force/Torque to FT
The Calibrated Sensing Range field displays the maximum rating for each axis of the selected calibration.
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel:+1 919.772.0115 • Fax:+1 919.772.8259 •
Table 2.1.
and Section 11.2—Calibration Information
Figure 6.7—Configurations Page
C-41
Section 8.3—Console "CAL" |
(netftcalapi.xml).
Values.
www.ati-ia.com