Library And Tape Drive Configurations - Sun Microsystems storagetek sl500 Reference Manual

Modular library system
Hide thumbs Also See for storagetek sl500:
Table of Contents

Advertisement

Library and Tape Drive Configurations

Library and Tape Drive Configurations
Note – You might not be able to use the StreamLine Library Console to configure
the library and tape drives. Use the CLI commands in the following tables or type
help lib or help drive for a list of the commands.
TABLE B-1
CLI Commands for Library Configuration
allowpartitions <print|on|off>
autoclean print (firmware level 1022)
autoclean <on|off>
(firmware level 1022)
cap <module#> <io|storage>
cartridge print
cartridge print reserved
(firmware level 1022)
clearcartcount print
(firmware level 1022)
clearcartcount <label> count
(firmware level 1022)
cleanwarnthreshold print
(firmware level 1022)
cleanwarnthreshold <count> <drivetype>
(firmware level 1022)
lib getconfig
250 SL500: Interface Reference Manual • July 2008
Enables/disables the partitioning feature.
Note: You must have an advsrv password for this
command.
Shows the library's current setting
Sets the auto clean option on or off. On causes tape drives
to be automatically cleaned when needed. Off disables
automatic cleaning. If the host software is handling tape
drive cleaning, set the option to off.
Configures the specific module's CAP as input/output or
storage
Shows the location, volume serial number, and media type
for all cartridges
Shows the location, volume serial number, and media type
for reserved cartridges
Shows the library's current list of cleaning cartridges and
cleaning counts
Sets the number of times a particular cleaning cartridge
can be used. The cartridge must be in the cleaning list. The
cleaning list is not complete until the audit is finished.
Shows the library's current warning threshold count for
cleaning cartridges
Sets a warning threshold count for the number of cleans a
cartridge can perform for a given tape drive type before a
warning is issued. <drivetype> is "lto" or "dlt". If the
value is set to 0, no warning is issued.
Shows the library configuration
Revision: F • 96122

Advertisement

Table of Contents
loading

Table of Contents