Checking The Starter Drive; Checking The Freewheel - Husqvarna FC 450 2014 Repair Manual

17 ENGINE
17.4.41

Checking the starter drive

-
Check the gear mesh and bearing of starter idler gear
If there is damage or wear:
-
Change the starter idler gear.
-
Check the gear mesh and bearing of torque limiter
If there is damage or wear:
-
Change the torque limiter.
-
Check the gear mesh and bearing of freewheel gear
If there is damage or wear:
-
Change the freewheel gear or bearing.
8
-
Check freewheel for damage and wear when it is disassembled.
If there is damage or wear:
-
Change the freewheel.
-
Check the gear mesh of starter motor
If there is damage or wear:
-
Change the starter motor.
(D
-
Change the O-ring of the starter motor.
-
Connect the negative cable of a 12 volt power supply to the housing of the starter motor. Connect the positive cable of the
power supply briefly with connector of the starter motor.
If the starter motor does not turn when the circuit is closed:
-
Change the starter motor.
17.4.42

Checking the freewheel

•
O
8
for damage and wear.
fD
for damage and wear.
0
for damage and wear.
-
Insert freewheel gear
wise; do not wedge!
-
Check the locking action of freewheel gear
If the primary gear does not turn clockwise or if it does not lock counterclock­
wise:
-
Remove the freewheel. (..- p. 168)
-
Turn the freewheel 180
-
Install the freewheel. (..- p. 168)
304693-10
304688-10
for damage and wear.
O
into primary gear@, turning the primary gear clock­
°
.
O.
167